Skip to main content
Nov 10, 2016 6:03 PM UTC
Question

Re: Anyway I can select just the top surface for my analysis?

Kong,

First, do you have an error free mesh?  You can mesh the model without running it.  What does it look like?

    4 replies

    Nov 14, 2016 7:51 AM UTC

    Hi, so I have attached my part file and I have tried to change the surface region but I'm not sure I have done the right thing as it still shows the same problem. While i was running the mesh it always crashes so I'm not too sure what's the problem. Hopefully you guys can check the file out and help me out? Thanks so much . I would wanna constraint the displacement at the bottom surface and putting the force on the top.

    Nov 14, 2016 8:11 AM UTC

    I have tried running mesh but it comes with the same error. Is there a problem with the surface that I have created?Screenshot 2016-11-14 16.10.33.png

    Screenshot 2016-11-14 16.09.16.png

    Nov 14, 2016 9:33 AM UTC

    I can't open your file as you're using the Educational version; but from your last screenshot, it looks like the problem is with the 'edge' surface, not the top one.

    Because this surfaces touches itself at various points (and with an acute angle), it's possible that these points are where the mesh falls over.  You might need to model it with small gaps instead of touching, and then use either contact interfaces or rigid links (or something else?) to connect the places where the waves touch.

    I'm just guessing though...