Skip to main content
Jun 20, 2016 3:38 PM UTC
Question

Re: A Creo Challenge for fun

It's 40 mm.  I scaled it off the drawing to confirm it.  And the drawing is actually inserted into the model as shown below.

40_mm.jpg

10_mm.jpg

    2 replies

    3-Newcomer
    Jun 20, 2016 3:43 PM UTC

    Steven Dunker wrote:

    It's 40 mm.  I scaled it off the drawing to confirm it.  ...

    Scaled the drawing!   Did you read the title block?

    Capture.JPG

    Jun 20, 2016 4:49 PM UTC

    Funny thing about ISO is that they do allow assumptions.  (go figure!)

    The fact that it was not dimensioned, section B-B may be applied.