Skip to main content
Sep 8, 2015 8:27 PM UTC
Solved

Offset Lines

When I make offset lines going from the bolt to the hole in the skin, it works fine.  But when I try to make the final offset line from the nut to the hole in the skin, the line always winds up in the middle of the other line as noted below.  Does anyone know how to fix this?  Thanks in advance.

 

 

    Sep 9, 2015 2:59 PM UTC

    It looks like the offset line is connecting to the wrong side of the hole in the skin.  Try picking on the end of the cylindrical surface or axis that you want the offset line to connect to.

    You can also try moving the HiLok further from the skin before creating the offset line and then moving it back to the desired position.

    2 replies

    Sep 9, 2015 2:59 PM UTC

    It looks like the offset line is connecting to the wrong side of the hole in the skin.  Try picking on the end of the cylindrical surface or axis that you want the offset line to connect to.

    You can also try moving the HiLok further from the skin before creating the offset line and then moving it back to the desired position.

    Sep 9, 2015 3:22 PM UTC

    Mark is correct, you have to be sure what side of the cylinder or axis you pick.

    I like to show the axes for the features/components I want to "connect" and over exaggerate them so when I select them it becomes easier to choose the "side" I want the line to generate from.  I can reduce the length afterward.