Recently active
And don't forget to factor in the cost to travel to Indian to take a course:airfaremealsmotellocal transportationetc.
Opened or imported?
Richard,See if this document will help you.
Got the pdf. Thanks.
Here is the same model with a 5° draft on three sides.
It doesn't really matter, because the mapped mesh can still be applied, even on a 95° angle as shown below. I mapped mesh the corner-round to show you.
One way to use mapped mesh in the model is to set up some volume regions. I used one mapped mesh in the model below. You're using the wedge element on the rounded ends, and those elements will give you a different color. Will this work for you?
I imported a model and nothing shows up as far as visible geometry. However, when I go to layers and select SolidGeom, I can see the outline of the part. Is there a way to see the actual geometry, or did I just get a bad import. Thanks in advance.
Thanks for the reply. I posted this because I have little experience with layers. But your solution worked, and I liked your explanation prior to the solution. I always wondered why I couldn't see the geometry on these imports.
Richard,Do you have the same problem if you're using the IPS system of units?
Interesting.
I'm using Creo Simulate 3.0 (M090) commercial.
I'm not seeing that "problem", as shown below. The legend values are not in engineering format. This is displacement, and the same format shows for stresses.
The first thing I would do is move this discussion to the Analysis and Simulation group. I don't know of a way to format the legend numbers, but now that it's been brought up, I will look into it.
Screenshots please!
I wonder if it will be an additional cost to the core? Time to call my sales rep.
PTC would not be investing R&D revenue without a cause. Somewhere in the acquisition process, as it should have been in the determination of need (DON) phase, PTC moved forward to implement G3 in Creo 4.
See if this answers the spiral on the right-hand side of your image. File attached from Creo 3.
Well...I guess it's nice to know that the ying-yang is on our side.
It appears that PTC would not implement G3 unless they have a demand for it. Perhaps they already have their customer base validated.
Dean,Did you know Creo 4 will have G3?
Yes....it does.
The STEP file from Alcoa looks like this.
I don't know, but it really got this guys attention. I hope they don't change the Creo ribbon to this color .
Community,Below and attached are images of the 312-12 Receptacle. I went to the Alcoa web site, and the STEP file they have for downloading is not the correct geometry. I contacted Alcoa, and they stated that was the only CAD file for downloading. Does anyone have this in 3D that can be imported into Creo and willing to share? Thanks in advance.
Already have an account? Login
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.