Skip to main content
Jun 24, 2016 6:26 PM UTC
Solved

Creo Sheetmetal - Joggles

Can I make a joggle under the Flange tool?

 

    StephenWAnswer
    Jun 24, 2016 8:14 PM UTC

    Well, it sort of depends on your end goal. You'll never get sheetmetal to give you a flat pattern on that part since you have intersecting bends.

    If I was modeling it, I would just model it as a solid then convert it to sheetmetal using the shell function.

    14 replies

    StephenWAnswer
    Jun 24, 2016 8:14 PM UTC

    Well, it sort of depends on your end goal. You'll never get sheetmetal to give you a flat pattern on that part since you have intersecting bends.

    If I was modeling it, I would just model it as a solid then convert it to sheetmetal using the shell function.

    Jun 25, 2016 4:03 PM UTC

    You will also notice that Catia considers this a "rib".

    I suspect the joggles were "crafted" and then joined to the main body.

    This is not much different than the toaster body that shows up in several Creo sheetmetal tutorials.

    Not sure how image 3 correlates to 1 and 2.  If you consider image 2 turned 90 degrees from image 1, it seems correct.  Image 3 is something completely different.

    Jun 26, 2016 7:43 PM UTC

    ‌Did you create your model in Parametric, shell it, then flatten it?