Skip to main content
Mar 30, 2014 1:22 AM UTC
Solved

Creo 2.0 and Windows 7

I just installed M100. I looked at the applications tab to make sure all of the apps were there, such as cabling, piping, mechanisms, simulate, etc.

 

When I logged out from the administrator account and logged back in as a user, some off the apps dropped out, such as cabling and piping. When I logged back in as admin, they were no longer there either.

 

Has anyone else experienced this?

Mar 31, 2014 3:59 PM UTC

Some of the application e.g. Cabling, Piping will be there if you are in assembly mode (File > New > Assembly > Ok > Switch to Applications and check available applications). Applications will be available if you have license for them.

You can make a try by enabling the license in session using File > Options > Licensing > Refresh License List > Check all licenses, now create part or assembly and check the assemblies.

 

Hope this will help.

 

Regards,

Mahesh

 

1 reply

Mar 31, 2014 3:59 PM UTC

Some of the application e.g. Cabling, Piping will be there if you are in assembly mode (File > New > Assembly > Ok > Switch to Applications and check available applications). Applications will be available if you have license for them.

You can make a try by enabling the license in session using File > Options > Licensing > Refresh License List > Check all licenses, now create part or assembly and check the assemblies.

 

Hope this will help.

 

Regards,

Mahesh