Skip to main content
Feb 3, 2014 6:16 PM UTC
Question

.

 

 

 

 

4 replies

Feb 3, 2014 10:05 PM UTC

Did you try to place fasteners by Interface ? As s standard part I'd suppose it should have one predefined.

you can place as many as you need at one placement session, and with automation in many cases. If assembly side has "recieving interfaces" then you have all the job done by Creo automatically.

Feb 5, 2014 8:20 PM UTC

Fastener interfaces are for assembly modeling not FEA.  Simulate fasteners are idealizations that create contacts, measures, springs, etc. at the interface.  Unfortunately it's a royal pain in the keister if you have many bolts...at least with Creo 2.0.  Unless somebody out there knows of some trick...

I suppose you could use a mapkey but that's not a true copy.  I end up not using built in fasteners much since I usually have more than two objects to clamp to and have to create them manually myself and I sometimes have to use nonlinear analyses.  I'd rather not have to create all the fasteners only to replace them later.  Hopefully Creo 3.0 has some new funtionality up it's sleeve that will help.  I seem to recall reading somewhere that fasteners are slated to improve.

Even if you could define fastener profiles (like beams) that you could select from and place (similar to the repeat command in an assembly), would make life much easier.

Feb 6, 2014 5:12 PM UTC

Via springs or somewhat crudely via idealized beams+a few springs and setting up surface regions, contact pairs between parts, and measures.  Depends on how exact you need to replicate the fasteners and whether or not you need preload.  It is 10x's more involved than just using simulated fasteners but sometimes you have to do it the old school way...which is basically what simulated fasteners are doing.  Here's a little reading on the subject:

http://www.ptc.com/cs/cs_27/howto/mst12163/mst12163.pdf

Mar 10, 2014 8:37 AM UTC

Copy-Paste works in some extent (no right mouse options for 2 ref required), but then still you have to rename all "Copy_of_Copy_of..." fasteners later on. Some naming convention would be nice to have too.

Pattern works in some extent if you use beams.