Skip to main content
Mar 24, 2025 10:53 PM UTC
Question

excluded elements warning still shown in the solver output file even after 'IEAC" is turned on.

I have added IEAC (Exclude elements autogem control) to my fixed constraint areas. Autogem mesh also reflects the IEAC control. However, in the solver output file, i still see a warning" Excluded elements may be needed near constrain". Is this normal ?

4 replies

Mar 25, 2025 6:09 AM UTC

This is only perhaps not okay if, for example, point constraints are poorly set so that singularities actually arise.

Mar 25, 2025 1:21 PM UTC

Hi Skunks,

Thanks for responding. I have an edge selected as a fixed constraint. Once i exclude them from the analysis (ignore stresses), then shouldn't the singularities be omitted?

Mar 25, 2025 1:34 PM UTC


In the case of a singularity, the stresses are also distorted at a distance.

Normally, the mesh is also refined at the singularity.

(in my job, I have 95% of my FEM without singularities).

Apr 27, 2025 3:21 PM UTC

Hi @VM_10276937,

 

I wanted to see if you got the help you needed.

If so, please mark the appropriate reply as the Accepted Solution. It will help other members who may have the same question.
Of course, if you have more to share on your issue, please pursue the conversation. 

 

Thanks,
Anurag