Skip to main content
Nov 8, 2021 1:23 PM UTC
Solved

Welding: Weld Wizard: Preparation and Solid weld

Hello everyone.

 

I have an issue: Two pipes with straight edges (i.e. not prepared edges) are connected to each other. By using the Weld Wizard I create preparation with the following parameters: 2 mm root opening, 2.5 mm depth and bevel angle of 35°. Everything works well except that the weld being created as a surface. When I choose "Solid" in "Weld geometry type" Regeneration failure message pops up. How do I get Solid weld type?

I will appreciate some help in solving this issue. 

 

Best,

Sergey

SergeyAnswer
Nov 8, 2021 1:40 PM UTC

I think that I found solution: Weld size should be equal to the pipe thickness in order to create a solid weld. 

In my opinion this is a very usefull information.

 

2 replies

SergeyAuthorAnswer
Nov 8, 2021 1:40 PM UTC

I think that I found solution: Weld size should be equal to the pipe thickness in order to create a solid weld. 

In my opinion this is a very usefull information.

 

Nov 22, 2021 6:46 PM UTC

@Sergey 

Thanks for sharing the details. 

You may accept your comments on post as solution.