Skip to main content
Oct 20, 2022 5:49 PM UTC
Solved

Unable to project curve onto sketch

This may be a somewhat silly question because I'm relatively new to Creo, but for some reason I can't project my equation-defined datum curves into a sketch. I have followed the support page for this exact process but when I try to select the curves for projection into my sketch, nothing happens and the curves aren't selectable in the modeling window. 

For reference, I am using Creo Parametric 7.0 and am trying to design something defined by epicycloid and hypocycloid curves.

tbraxtonAnswer
Oct 20, 2022 7:53 PM UTC

This is what you want to use the projection for? Unhide the layer with the curve and you should be able to see and project it.

tbraxton_1-1666295591517.png

 

tbraxton_0-1666295528201.png

 

 

14 replies

Oct 20, 2022 5:58 PM UTC

Are you trying to use an existing curve as a reference or are you trying to project on to a plane or surface?

I tested with a simple circle by equation and was able to use project in the sketch and I used Project in the model modifiers tab.

Did you test with something simple to make sure the process was good?

Maybe a screenshot would help or a link to the support page you were using would help

Oct 20, 2022 7:02 PM UTC

This is the support page I was using: To Project a Curve into a Sketch (ptc.com)

I am trying to project some existing datum curves into a sketch so that I can make an extrusion using them. I tried projecting them into another plane, using them as is, and pretty much everything I can think of and none of it has worked.

This is where I run into problems when I follow the suggestions on the Creo support page: I select the curves and they don't show up so I can't use them.

Oct 20, 2022 7:21 PM UTC

If you are using a commercial license, can you post a model with the curve from eqn in it so we can investigate it?

Oct 20, 2022 6:03 PM UTC

I just tested this in Creo 7.09. I have a dtm curve from eqn feature in the model. I am able to project this curve in sketch mode for use within sketcher when creating a sketched datum curve.

 

tbraxton_0-1666289010029.png

 

Oct 20, 2022 6:34 PM UTC

I would guess that because your equation curve has "vertices" Creo cannot use is it in a projection.  You may need to create copies of individual cusps to use the projection feature.  You might also want to consider creating only one cusp and patterning it.