Skip to main content
Apr 24, 2023 10:33 AM UTC
Question

Surface Selection

Hi Created cylinder in creo by using extrude, I need to use this surface in optical analysis, But when i click surface, just half of them selecting, for the other one we need to select with CTRL, But this is no good my optical simulation, Simulation software requires me just 1 clicking , 

How can built this part as a on single surface,  

newones.jpg

 

 

 

13 replies

Apr 24, 2023 10:38 AM UTC

If it has to be one surface, .... you will need to use another software.

Creo always makes cylinders out of (2) surfaces.

Apr 24, 2023 12:23 PM UTC

Is there any way to create one surface

Apr 24, 2023 12:24 PM UTC

@Dale_Rosema was correct with his response. Creo always splits cylinders in the geometry kernel.

Apr 24, 2023 12:19 PM UTC

You can execute this using a single selection click in Creo by the following method:

tbraxton_1-1682338776196.png

tbraxton_2-1682338787445.png

 

 

Apr 24, 2023 12:22 PM UTC

Yes but it  should be a single surface in Creo, Unless it is single surface, My optical software does not recognize it. 

Apr 24, 2023 12:53 PM UTC

Creo always splits a circle.  If you can get by with an almost complete cylinder, you could use two arcs to make the extrusion, one 359.5° and the other 0.5°, creating a sliver for the second surface.

Apr 24, 2023 1:01 PM UTC

Hi,

what if you create Revolve surface feature with angle 359.9 degrees angle which has the same diameter as solid geometry and select this surface feature as reference for simulation.