Skip to main content
May 30, 2024 12:29 PM UTC
Solved

Snap problem

Hi, suddenly my creo started giving problems with the snap no longer taking references, I tried to load the config.pro file that I had exported previously but it still doesn't work. if I open a new project the snap works correctly

Dome_dvAnswer
May 30, 2024 4:00 PM UTC

Fixed by turning off perspective view.

4 replies

May 30, 2024 12:46 PM UTC
Dome_dvAuthor
May 30, 2024 3:21 PM UTC

I've already tried but it doesn't change

 

May 30, 2024 3:24 PM UTC

If it is working normally in a new part, then the setting is correct. There is something about your part that is not allowing references.

There used to be an issue with mirror, where when you tried to add a reference, it would give you an error "additional references not allowed", not sure if this is still the case.

Dome_dvAuthorAnswer
May 30, 2024 4:00 PM UTC

Fixed by turning off perspective view.