Skip to main content
Dec 2, 2021 12:12 PM UTC
Question

Remap middle mouse button

As you may know the middle mouse button is for rotating and dragging the part.

Sadly I can't work with Creo at all at times since I have a hardware problem with my middle mouse button.

Where can you remap it to a different button?

4 replies

Dec 3, 2021 7:53 AM UTC

There was a similar question before, here - "Middle Mouse button customization": https://community.ptc.com/t5/3D-Part-Assembly-Design/Middle-Mouse-button-customization/td-p/222637 

CreonicAuthor
Dec 8, 2021 3:56 PM UTC

Does Autohotkey actually work with fewer buttons? I mean, right click also has features in Creo - just remapping that and then actually having both features work against eacah other / both at once would be rather contraproductive.

Dec 3, 2021 6:47 PM UTC

@Creonic wrote:

As you may know the middle mouse button is for rotating and dragging the part.

Sadly I can't work with Creo at all at times since I have a hardware problem with my middle mouse button.

Where can you remap it to a different button?


Hi,

if you have multibutton mouse then install software that comes with the mouse and check its functionality.

CreonicAuthor
Dec 8, 2021 3:54 PM UTC

Hello,

My mouse is a multibutton mouse but as said, this is a hardware problem and cannot be fixed by software. It takes time until I can put in a new clicky switch for the middle button.