Skip to main content
Jun 11, 2024 1:43 PM UTC
Solved

Regenrate drawing not responding

Hello,

 

i am using creo 10 and when i try to regenerate and then save the drawing, the window says not responding.

see attached error page.

 

Br,

sandeep c.

StephenWAnswer
Jun 11, 2024 6:44 PM UTC

There are a lot of potential reasons for this. If you have maintenance with PTC, you can send the traceback to PTC and they may be able to tell you the issue. They may also request the files

If it is a large assy, make sure you clean up model errors/warnings. 

If it is PDMLink, you can try it in a new workspace.

It's pretty impossible to diagnose the real issue from what has been given.

2 replies

StephenWAnswer
Jun 11, 2024 6:44 PM UTC

There are a lot of potential reasons for this. If you have maintenance with PTC, you can send the traceback to PTC and they may be able to tell you the issue. They may also request the files

If it is a large assy, make sure you clean up model errors/warnings. 

If it is PDMLink, you can try it in a new workspace.

It's pretty impossible to diagnose the real issue from what has been given.

Sandy7Author
Jun 12, 2024 5:34 AM UTC

hi Stephen,

 

got you. thanks for reply.

 

Br,

sandy