Skip to main content
May 25, 2021 7:36 AM UTC
Solved

points are not selected when making a spring mechanism

Hi, I was trying to make a simple spring mechanism for school project

When creating this, I faced a problem that two pairs of dots are not simultaneously selected.

As shown in the attached figure, pnt0 and pnt1 were set on the top and bottom of each part, respectively.
I tried to select the other point by pressing and hold Ctrl key , but it didn't even work.
How should I solve this problem? I don't know what the problem is.

 

스크린샷(33).png

HaydenaAnswer
Oct 14, 2021 3:55 AM UTC

Dear SJ

 

I found out why we cannot select the second point for the spring mechanism.

 

Your packaged component must be an assembly component that is not fully constrained.

 

Please find the attached image.  Thank you!

 

螢幕擷取畫面 2021-10-14 114724.gif

1 reply

HaydenaAnswer
Oct 14, 2021 3:55 AM UTC

Dear SJ

 

I found out why we cannot select the second point for the spring mechanism.

 

Your packaged component must be an assembly component that is not fully constrained.

 

Please find the attached image.  Thank you!

 

螢幕擷取畫面 2021-10-14 114724.gif