Skip to main content
Dec 7, 2021 12:35 AM UTC
Solved

Parameters for model units like mass and density

Is there a parameter to show what the model units are? 

 

For example: On a drawing I want to show the model mass so I use &PRO_MP_MASS[.2].  But I want to be able to show the units of the reported mass.  I feel like there should be a parameter that is something like "&PTC_MASS_UNITS" or "&MODEL_MASS_UNITS", but I haven't been able to find anything.

tbraxtonAnswer
Dec 7, 2021 11:39 AM UTC

See this pervious thread addressing this question. The method presented by @BrianMartin should work for you.

 

https://community.ptc.com/t5/3D-Part-Assembly-Design/Pro-E-Model-unit-parameter/m-p/150925 

2 replies

tbraxtonAnswer
Dec 7, 2021 11:39 AM UTC

See this pervious thread addressing this question. The method presented by @BrianMartin should work for you.

 

https://community.ptc.com/t5/3D-Part-Assembly-Design/Pro-E-Model-unit-parameter/m-p/150925 

Dec 9, 2021 6:47 PM UTC

Thanks @tbraxton.  I was hoping there would be an easier way since it seems like an easy thing to grab and a good way to check material assignments.  The method Brian Martin suggests will be difficult to apply to an already existing assembly.