Skip to main content
Nov 17, 2021 12:54 PM UTC
Question

Laser cutting spline lines

I am using Creo Parametric - Release 3.0 (connected) 3.0 M040

When we create sheet metal parts to be cut on our laser, many have complex splines, rather than smooth arcs. Is there a way to have Creo export DXFs from the drawing with best fit curves and arcs rather than splines and polylines?

5 replies

Nov 17, 2021 2:53 PM UTC

Try setting this config option to yes. This should export the splines as arcs using a DXF output.

 

intf2d_out_splines_to_arcs

 

This will not necessarily fix everything as it applies only to splines that represent arcs.

Description: Yes - splines geometrically representing arcs will be exported as arcs. No - such splines will be exported as splines.

 

If this does not address the issue you will probably have to use a 3rd party application to convert the splines to arcs in the DXF exports.

 

Nov 17, 2021 2:59 PM UTC

Seems to be a problem that has been asked about before:

 

Export DWG Drawing with Converted Splines to Arcs 

Is it possible to output a spline as lines and arcs when export drawing to DXF in Creo Parametric  

 

Doesn't seem to be an option. The options available when doing a DXF export are not helpful for this situation. You can specify splines be saved as polylines, but not approximate lines and arcs.

 

Nov 17, 2021 3:18 PM UTC

I was hoping that there was some development since that previous discussion (2012).

I'm going to try "intf2d_out_splines_to_arcs"

Nov 17, 2021 3:35 PM UTC

I had checked the config options for DXF but not the general intf2d_out options. Hopefully that will help, but I have my doubts.