Skip to main content
May 25, 2021 8:36 PM UTC
Question

"Insert here" bar missing

I am using Creo Parametric - Release 8.0 (connected) 8.0 8.0.0.0

Hello
I can't see the "Insert Here" bar in the Creo 8.0.0.0
I attached capture files. Could you check it?
Thanks

    5 replies

    May 25, 2021 8:55 PM UTC

    Not seeing any files attached.

     

    This is from Creo 8.0.0.0:

    TomU_0-1621976088020.png

     

    May 26, 2021 6:07 PM UTC

    Starting in Creo 7 the "Insert Here", or Insert Indicator, was switched to the green bar. It behaves identical to the Insert Indicator in that you can drag and drop it to enter Insert Mode. Then RMB > Exit Insert Mode to exit. 

    May 26, 2021 11:39 AM UTC

    @hwanho wrote:
    I am using Creo Parametric - Release 8.0 (connected) 8.0 8.0.0.0

    Hello
    I can't see the "Insert Here" bar in the Creo 8.0.0.0
    I attached capture files. Could you check it?
    Thanks

    Hi,

    see green horizontal line in picture uploaded by TomU. This is former "Insert Here" bar.

    May 26, 2021 6:07 PM UTC

    Not sure if this is your case or not, but this article just rolled out from PTC:

    https://www.ptc.com/en/support/article/CS345672

     

    TomU_0-1622052457220.png

     

    May 5, 2022 10:10 AM UTC

    It's the same in Creo 7.

    Go to the model tree settings and make sure "Features" is selected.

    If you press apply, the bars should come back.

    Kristof_D_0-1651745373723.png

     

    I'll log another case to E-support and suggest this as a change.