Skip to main content
Apr 18, 2025 4:58 PM UTC
Question

Hole Note Refinement

Hi Folks,

Using Creo 7.0.8.0

In the 'Shape' sub-tab of the 'hole' modeling feature ribbon, I recall the graphic used to show the tap-drill depth. I don't see this anymore. Nonetheless, is there a way to add drill depth to the note callout properly? This is omitted and only tap-depth is shown. Thank you.

 

Capture.jpg

Capture.jpg

3 replies

Apr 18, 2025 5:57 PM UTC

Creo 9.0.9.0 shows what you want for the note, but not graphically.

BenLoosli_0-1744998969944.png

BenLoosli_1-1744999019203.png

 

Apr 20, 2025 8:43 PM UTC

At some point, the GUI changed and now the tap drill depth is specified elsewhere:

pausob_3-1745181694362.png

It seems the reason your note doesn't show it is because you are using a custom hole table (UNC-2B_RTN ?) that has a callout definitions that do not display the dap drill depth...

Apr 28, 2025 8:01 AM UTC

Hi @wbottis,

 

I wanted to see if you got the help you needed.

If so, please mark the appropriate reply as the Accepted Solution. It will help other members who may have the same question.
Of course, if you have more to share on your issue, please pursue the conversation. 

 

Thanks,
Anurag