Skip to main content
Jan 11, 2021 11:25 AM UTC
Solved

Fuse the rod with the main body

Hi, I wanted to ask that how do I fuse this rod to my main body ?

Should I use the welding option?

Pic.JPG

tbraxtonAnswer
Jan 11, 2021 3:26 PM UTC

Two options:

Easy:  Extend the length of the rod so it is inside the main body

Correct: Extrude the rod and use the extrude up to next surface option so that it intersects the surface of the main body explicitly.

4 replies

Jan 11, 2021 2:33 PM UTC

I do not think weld feature is what you need. It appears that your main body is surface and the rod is solid geometry. Solidify the main body geometry then modify the rod such that it intersects the main body yielding a single solid.

Jan 11, 2021 3:21 PM UTC

I just done solidify the main body and I found out that there is still a gap between the rod and the main body. How to make sure that my plane is parallel to the inclined surface?

tbraxtonAnswer
Jan 11, 2021 3:26 PM UTC

Two options:

Easy:  Extend the length of the rod so it is inside the main body

Correct: Extrude the rod and use the extrude up to next surface option so that it intersects the surface of the main body explicitly.