Skip to main content
Mar 16, 2023 2:03 AM UTC
Question

flexible O-ring creation

I have created O-ring model with revolve feature with ellipse cross section with axial and radial distances.

 

Now i want to assemble them and simulate the actual assembly condition.

 

case 1 (Assemble on the shaft groove): inner diameter is constant and outer diameter will be squeezed which change the cross section of the Oring axially) 

 

case 2 (Assemble inside the Hole): Outer diameter is constant and inner diameter will be squeezed which change the cross section of the Oring axially) 

 

Is there a way to create a o-ring with reflect the assembly condition with relations just by changing the ID or OD rather than changing the cross section manually ? 

 

5 replies

Mar 16, 2023 12:26 PM UTC

You could make a family table.

The generic part could be at rest.

Then make (2) instances: One for assembling outer and another for inner. If you define the cross section with parameters, you could modify that in the family table also.

Mar 16, 2023 12:28 PM UTC

Thank you Dale for the response. is there any way to do this with single instance? pls let me know. 

Mar 16, 2023 12:32 PM UTC

There is the option of making the part flexible. This functionality was intended to handle the scenario you described.

 

About Flexible Parts (ptc.com)

 

Article - CS28948 - How to make a part or component in assembly flexible in Creo Parametric (ptc.com)

Mar 16, 2023 6:34 PM UTC

I would suggest also looking into To_Define_a_Flexible_Part  (Found under About Flexible Parts)- I use this to predefine flexibility in parts and assemblies when I know it will probably be flexed when used.  This adds the values and other features to the flexibility definition when adding model to an assembly.

Mar 16, 2023 5:30 PM UTC

Video of what @tbraxton suggested: