Skip to main content
Oct 10, 2020 9:02 PM UTC
Solved

Explode sub-assembly into top-level assembly

Dear Community,

After creating exploded states in the sub-assemblies, I would like these states to be automatically active when exploding the top-level assembly. I mean, the sub-assemblies shall explode when the top-level assembly explodes.

How can I get that?

Thanks in advance!

 

Stefano Cristofanelli

Chris3Answer
Oct 13, 2020 11:17 AM UTC

Using the Default explode allows you to propagate it into the next higher assembly (start with the default explode in the next higher assembly). There was an idea for making this happen with other explodes but it was "archived" which likely means it won't be coming anytime soon.

 

https://community.ptc.com/t5/Creo-Parametric-Ideas/Subassembly-Explode-States-propagate-to-higher-levels/idi-p/470472

5 replies

Chris3Answer
Oct 13, 2020 11:17 AM UTC

Using the Default explode allows you to propagate it into the next higher assembly (start with the default explode in the next higher assembly). There was an idea for making this happen with other explodes but it was "archived" which likely means it won't be coming anytime soon.

 

https://community.ptc.com/t5/Creo-Parametric-Ideas/Subassembly-Explode-States-propagate-to-higher-levels/idi-p/470472

StetoAuthor
Oct 13, 2020 3:09 PM UTC

Dear Chris3 Pearl,

thank you very much for your reply. Finally, how can I save a custom exploded state as Default Explode? I tried, but I did not find out the way.

Best regards

 

Stefano Cristofanelli

Oct 13, 2020 7:01 PM UTC

Maybe some else knows of a trick but I am not aware of a way to do that.