Skip to main content
May 19, 2021 6:18 PM UTC
Solved

Creo Cabling Wire default name

I am using Creo Parametric - Release 4.0 (connected) 4.0 M050

Is there a way to define default Creo Cabling wire name parameter?
New wires had W0xx now have w-xx default names.
    May 20, 2021 9:15 PM UTC

    Hi @IAircraft_25,

     

    There is no parameter to change the default naming convention of a cabling wire. You need to manually change the parameter names by going to Parameters in Route group in Cabling tab > Select a Cable/Wire/Ribbon > OK > select the name and type the new name in value column > Apply > OK.

     

    Regards,
    Amol

     

    1 reply

    May 20, 2021 9:15 PM UTC

    Hi @IAircraft_25,

     

    There is no parameter to change the default naming convention of a cabling wire. You need to manually change the parameter names by going to Parameters in Route group in Cabling tab > Select a Cable/Wire/Ribbon > OK > select the name and type the new name in value column > Apply > OK.

     

    Regards,
    Amol