Skip to main content
Aug 21, 2023 11:58 AM UTC
Solved

Creating section views in drawing

Hi

How would I go about in creating section C-C in Creo 9.0 

I tried creating a zone and although that does give me the 3d view it does not give me an option to show the section lines.

IbrahimTayyab_0-1692619341115.png

 

 

tbraxtonAnswer
Aug 21, 2023 2:00 PM UTC

One work around would be to create the offset section view on the drawing but place it outside the drawing format border. It will not show up in the drawing when printed but will allow you to place the section lines for section C-C on a view within the border.

7 replies

Aug 21, 2023 12:11 PM UTC

In the model, you create an offset section.

In the drawing, when you set the section, you'll use Full(unfolded) in the section properties. You'll need and axis at the center to unfold in the drawing.

Aug 21, 2023 12:14 PM UTC

Oh, wait, I didn't see its a 3D view in the drawing. Zone is right, I haven't used it but a handful of times, don't think I ever needed section lines.

tbraxtonAnswer
Aug 21, 2023 2:00 PM UTC

One work around would be to create the offset section view on the drawing but place it outside the drawing format border. It will not show up in the drawing when printed but will allow you to place the section lines for section C-C on a view within the border.

Aug 23, 2023 11:28 AM UTC

Thanks a lot I completely forgot about offset section view. Also that's quite a neat workaround, I never thought about using the space outside the border.

Aug 21, 2023 2:04 PM UTC

Hi,

Offset x-section enables you to get following view. Unfortunately section view cannot be displayed in shading mode.

MartinHanak_0-1692626620931.png