Skip to main content
May 15, 2020 9:38 AM UTC
Solved

activate copy geometry in Creo3

Hello,

I have the standard version of Creo3 M050 and i can't use the copy geometry and publish geometry options (it's gray)

Do I have to activate them in the config.pro? If yes how?

Do i need a additional licens for this?

 

actual licens are:

4DNavigator, AE, Assyperformance, CDT, Data_for_PDGS, Detail, Design_Animation, Ecad, feature, flexible_modeling

 

 

 

Thank you for your help 🙂

SanathAnswer
May 19, 2020 12:26 PM UTC

@amazingwaldi, you need Advanced Assembly Extension license or  Pro/ASSEMBLY license module to access COPY geometry feature. Check if you have this Extension/ Module in your license file. If yes then you need to reconfigure the application to look for this license. If not then contact PTC sales to get the required license.

 

Steps to reconfigure Creo if you have the license is listed in the below link

https://www.ptc.com/en/support/article/CS60577

4 replies

May 19, 2020 10:28 AM UTC

Unfortunately, I think you need additional licence.

Il really don't understand why it's not part of the basic licence as, for me, it's a core feature. 🤔

May 20, 2020 6:15 AM UTC

Thank you @RaphMORIN for your help 🙂

SanathAnswer
May 19, 2020 12:26 PM UTC

@amazingwaldi, you need Advanced Assembly Extension license or  Pro/ASSEMBLY license module to access COPY geometry feature. Check if you have this Extension/ Module in your license file. If yes then you need to reconfigure the application to look for this license. If not then contact PTC sales to get the required license.

 

Steps to reconfigure Creo if you have the license is listed in the below link

https://www.ptc.com/en/support/article/CS60577

May 20, 2020 6:15 AM UTC

Thank you @Sanath for your help 🙂